| Customization: | Available |
|---|---|
| Material: | Plastic |
| Connection: | Welding |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
PE Electrofusion Sleeve/tape/weld Closure for pre insulated Pipe Joint/connection
INTRODUCTION
PE electro fusion sleeve is composite with PE back board and electrical wire which is pressed into PE back board by special lamination device. It is a kind of welding material of kinds of plastic pipes.
Composition
PE back board Electrical wire Terminal
Application area:
It is usually wider than that for metal reinforced corrugated pipe, is mainly used as a joint of PU insulation Pipe.
CONSTRUCTION CASE
PU Insulation Pipe
| Specification | |||||
| Steel pipe outside diameter (mm) | PE outside casing diameter (mm) | Width(mm) | Tic.mm | ||
| DN159 | 285 | 600 | 4 | ||
| DN219 | 315 | 600 | 4 | ||
| DN273 | 365 | 600 | 4 | ||
| DN325 | 420 | 600 | 5 | ||
| DN377 | 500 | 600 | 5 | ||
| DN426 | 550 | 600 | 6 | ||
| DN478 | 630 | 600 | 6 | ||
| DN529 | 655 | 600 | 6 | ||
| DN630 | 760 | 600 | 8 | ||
| DN720 | 850 | 600 | 8 | ||
| DN820 | 960 | 600 | 10 | ||
| DN920 | 1054 | 600 | 10 | ||
| DN1020 | 1155 | 600 | 12 | ||
| DN1220 | 1380 | 600 | 12 | ||
| Technical Data: | |||||
| All of the test according to the EN253-2003, ISO1183-2004, ISO6964-1986, EN728-1997 | |||||
| Final Test | Unit | Standard | Test Result | Result | |
| Raw material density | g/cm 3 | ≥0.935 | ≤0.961 | PASS | |
| Raw material melt flow rate | g/10min | ≤0.50 | 0.46 | PASS | |
| Appearance check | / | Internal and external surfaces are clean and free from other defects. | Pass | PASS | |
| Heat reversion | % | ≤3; shall not show any cracks | 0.89, No cracks | PASS | |
| Tensile yield strength | Mpa | ≥19 | 20.2 | PASS | |
| Elongation at break | % | ≥350 | 656 | PASS | |
| Stress crack resistance | h | ≥300 | Pass | PASS | |
OUR WORKING PLANT
CUSTOMER VISITING&DELIVERY
){kind=link}